Page 1 of 1
Beams not working correctly in 3D or Pan/tilt
Posted: Sat Feb 01, 2025 8:38 pm
by csubbiondo
I imported the profile for Intimidator Beam 360X. I had to make a few adjustments (colors were incorrect) but It does not show up in pan/tilt in steps. in 3D they show aiming towards the ceiling full blast white. nothing I do changes this.
washes shocks, spots in program all work correctly.
Re: Beams not working correctly in 3D or Pan/tilt
Posted: Sat Feb 01, 2025 11:53 pm
by support
Could you please post the library (the .xml file) ?
We will check it.
Re: Beams not working correctly in 3D or Pan/tilt
Posted: Tue Feb 04, 2025 4:10 am
by csubbiondo
I am not sure where to find the Library. here is a zip of my Show though. I am somewhat new to Show Xpress and May need some guidance.
Re: Beams not working correctly in 3D or Pan/tilt
Posted: Tue Feb 04, 2025 9:09 am
by support
This lightshow is for the version V9 of our software.
You are in the forum for the version V_II of our software.
Could you please post this in the forum for the version V9 of our software ?
here:
https://forum.thelightingcontroller.com